INSTALLATION PACKAGE

Running Board	2
Installation Instructions	1
Bracket	6
Bolt Pack	1
Light Wiring Kit       (optional)	1
"L" Strap	12

 

NECESSARY TOOLS

Ratchet wrench with ½" socket

Combination wrench

Variable speed drill w/ 3/8" hex head drive

Safety glasses

 

STEP ONE : Determine proper bracket placement

1. There are three places on the inside of the rocker panel werethe brackets need to be placed.

2. Loosely bolt (hand tighten) brackets to the humps on the inside of the rocker panel, as shown in Fig A. 

3. Do this with all brackets putting them in their proper places.

STEP TWO : Hooking up boards to brackets.

1. Place the running board on the brackets with the support bolts falling through the slots in the foot of the bracket

2. Hand tighten the board to the brackets using 5/16" lock nuts

3. Slide board in or out to desired location

4. Tighten down flange nuts under running board to lock into place.

STEP THREE : Installing "L" strap to pinch weld

1. Push board tight against vehicle and mark hole on pinch weld were you need to drill. (Fig. C)

2. Bolt strap to the pinch weld using a 5/16" bolt and flange nut. Do this with both sides of bracket with both straps. Using tec Screws will speed up the installation process )

3. Make sure foam tape is in proper place before bolting straps.

4. Check that all brackets are tight before stepping on boards.

That's SHARP !!!